Axis Q1604-E Network Camera; Status Led Behavior For Focus Assistant; Connectors And Buttons - Axis Communications Q1604-E Manual De Instalación

AXIS Q1604-E Network Camera

Status LED Behavior for Focus Assistant

Color Indication
Green Focus Assistant is enabled
The lens is optimally adjusted
Amber The camera has been moved, or an object has been placed in front of the lens.
Exit and restart the Focus Assistant.
The lens is less optimally adjusted.
Red The camera has been moved, or an object has been placed in front of the lens.
Exit and restart the Focus Assistant.
The lens is poorly adjusted.
LED Indicators
Note
The housing LED referred to in the table below is located in the housing.
Housing LED
(fan and heater)
Green
Flashing green

Connectors and Buttons

For specifications and operating conditions, see page 14.
Network Connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
NO TICE NO NO TICE TICE
The product shall be connected using a shielded network cable (STP). All cables connecting
the product to the network shall be intended for their specific use. Make sure that the
network devices are installed in accordance with the manufacturer's instructions. For
information about regulatory requirements, see Electromagnetic Compatibility (EMC) on
page 2.
Indication
Normal operation.
Single flash: Heater error
Double flash: Fan error
Triple flash: General error
Alarm events will be triggered through the camera's input port.
Contact your Axis reseller for information about spare parts and
troubleshooting.
12