List Of Alarms - ABB PowerValue 11 LI Up Manual De Usuario

66
—

2 .2 List of alarms

en
A B B U P S P R O D U C T S A N D S O L U T I O N S
Overload in
battery
mode
In case of overload in AC mode, this symbol "
*The display shows only the load level of the "protected AC output sockets".
—
Table 5: Display views
Fault condition LCD
Output short circuit
Overload
Overcharge
Battery failure
High output voltage failure
Over-temperature
In case of overload alarm, a
beep will sound every
0.5 second.
" will appear.
Solution
Disconnect the short-circuited load, and restart
the UPS.
Disconnect all output loads and restart the UPS.
Call for service immediately
Replace the battery
Call for service immediately
1. Switch the unit off, and let cool down the
unit.
2. Remove excessive loads and let the unit
cool down.