EdilKamin CHARME Instalación Uso Y Mantenimiento página 32

sk tecnica charme karma feeling multilingua_FOTOCOP_mod.qxp 03/07/2009 12.25 Pagina 33
FEELING – Fitting the outer housing
• Metal details provided and
used:
4 screws M6x12
4 silicon spacers for top
8 flat washers Ø 6
- the 2 screws M6x12 and 2 flat
washers M6 are used to attach
the upper frontage piece made of stone.
- the 2 screws M6x12 and 2 flat
washers M6 are used to attach
the lower frontage piece made of stone.
- for the 4 spacers and the 4 washers,
proceed as follows:
• insert the 4 spacers for stone in the
4 respective holes provided in the cast
iron top;
• apply the stone top to
ensure that it is completely flush;
• wherever necessary, add a flat washer
between the silicon spacer and the cast
iron top, until the stone top is perfectly
flush with the stove.
Detail "X"
2 screws
The stove is delivered fully assembled. If for any reason you need to remove the housing, proceed as follows.
Unscrew the rear (80) and the two profiles (6); remove the lid and the cast iron top and the one made of stone (32).
Now pull the stone sides of the housing (137-138-139) out and, if necessary, also pull out the two aluminium profiles (83)
clamped onto the baseplate hinges.
Now pull the upper forward frontage piece (24) out from the clamps in the grid structure.
To remove the lower forward frontage piece (19), unscrew the two screws: see detailed drawing "X".
To reassemble, follow the same instructions in reverse.
32