Intended Use - GCE MEDIMETER Instrucciones De Uso

ENGLISH
INSTRUCTION FOR USE: MEDIMETER®
1. FOREWORD
GCE Flowmeters are medical devices classified as class IIa according to the
Medical Device Directive 93/42/EEC.
The Compliance with essential requirements of 93/42/EEC Medical Device
Directive is based upon ISO 15002 standard.

2. INTENDED USE

Flowmeter is a device intended for the administration of the following
medical gases in the treatment and care of patients:
• oxygen
• medical air
• nitrous oxide
The product is not intended to be use with air or nitrogen for driving
surgical tool.
This low pressure regulator is intended to be fitted to medical gas pipeline
system terminal units in hospital or ambulance car or to quick connector
outlet of medical regulator, with nominal pressures up to 5 bar.
3. OPERATIONAL, TRANSPORT AND STORAGE
SAFETY REQUIREMENTS
Keep the product and its associated equipment away from:
• heat sources (fire, cigarettes, ...),
• flammable materials,
• oil or grease, (especially be careful if hand cream is used)
• water,
• dust.
The product and its associated equipment must be prevented from falling
over.
Use only the product and its associated equipment in well ventilated area.
Always maintain oxygen cleanliness standards.
Before initial use the product should be kept in its original packaging. GCE
recommends use of the original packaging (including internal sealing bag
and caps) if the product is withdraw from operation (for transport, storage).
Statutory laws, rules and regulations for medical gases, accident prevention
and environmental protection must be observed.
O
2
Air
N O
2
3/124
EN