Tapping - Evolution EVOMAG 28 Instrucciones Originales

www.evolutionpowertools.com
spindle through the sight slots. (Fig. 18)
EN
ensuring it passes through both sight slots.
faced mallet.
Retrieve the drift.
WARNING: Take care to ensure that the ejected arbor is not
damaged by falling to the ground. Also ensure that the ejected
FIG. 18
arbor cannot pose a danger to fellow workers as it exits the
machine.
the three (3) socket head screws.
Store the arbor, arbor support bracket and all hardware for
future reinstallation.
Accessories such as a drill chuck with a No.3 Morse Taper shank
or a No.3 MT Twist Drill can now be inserted directly into the
drive spindle.
ES
on the accessory is felt within the drive spindle.
accessory into the drive spindle. The friction fit formed by the
Morse Taper will hold the accessory firmly and securely in place.
WARNING: When handling cutting accessories such as drill bits,
etc. the operator should wear protective gloves.

TAPPING

EVOMAG75
Note: This machine has a reversing facility and can therefore be
used, with suitable accessories, to tap (thread) pre-drilled holes.
WARNING: This machine does not have a clutch. All four (4)
gears are direct drive. Any tapping chuck and/or tapping collet
that is inserted into this machine must have an integral clutch.
must disconnect the drive to the chuck.
FR
Follow the recommendations, advice and instructions supplied
by the manufacturer of the tapping chuck and/or collet.
27