Installing An Annular Cutter - Evolution EVOMAG 28 Instrucciones Originales

www.evolutionpowertools.com
panel to switch on the machine's motor.
machines motor.
unusual noises or vibrations.
WARNING: Do not use the machine if any vibration or unusual
noises are evident.
WARNING: Do not use the machine if the magnetic adhesion is
questionable.
If any damage, unusual noise or vibration is detected during
testing, have the machine serviced and checked by a qualified
technician, or if under warranty, refer to the warranty
agreement.

INSTALLING AN ANNULAR CUTTER

ALL MACHINES
WARNING: Annular cutters are very sharp. It is recommended
that the operator wears protective gloves whilst handling a
cutter during installation or removal.
WARNING:
through the bore in the cutter smoothly. (Fig.11)
the arbor (Fig. 12) are not protruding into the arbor bore.
set screws in the arbor.
very slightly rotating the cutter backwards and forwards.
Continue until the set screw has settled onto the flat.
located squarely onto the cutter flat, preventing the cutter from
becoming loose.
(Fig. 9) on the machine's switch
(Fig. 10) to switch off the
23
FIG. 10
EVOMAG75 shown above.
Others machines are very similar.
FIG. 11
FIG. 12
EVOMAG75 shown above.
Others machines are very similar.
EN
ES
FR