General Guidance; Installing A 3 Jaw Chuck - Evolution EVOMAG 28 Instrucciones Originales

www.evolutionpowertools.com

GENERAL GUIDANCE

HOLE CUTTING WITH ANNULAR CUTTERS
Note: EVOMAG28 is fitted with a 10 Amp 230V (5 x 20mm)
EN
Surge Fuse. This is located in a fuse holder found in the
machine's switch panel. (Fig. 13) If the machine fails to operate,
check the fuse. If it has "blown", replace it with an identical type.
Correctly position the machine on the work-piece, with the
electromagnet energised and the safety chain/strap securely
in place.
FIG. 13
the machine's switch panel.
cutter makes contact with the work-piece.
cutter to cut freely through the work-piece.
beneficial to periodically raise the cutter and clear any build up
WARNING:
raised and the arbor, cutter and motor completely stationary.
ES
machine's motor.
WARNING: On completion of the cut the pilot pin will eject
an ejected slug thereby ensuring the safety of any colleagues
working nearby. Consult the site Safety Officer for extra specific
guidance.
fails to be ejected from the cutter, this could be caused by the
lower the cutter onto a flat area of the work-piece. This will

INSTALLING A 3 JAW CHUCK

EVOMAG 28
A three (3) jaw chuck (part HTA153) can be fitted into the main
drive spindle of this machine. This enables EVOMAG28 to take
FR
standard twist drills up to Ø1/2in.
WARNING: Ensure that the machine is disconnected from the
mains power supply when installing the 3 jaw chuck.
25