Troubleshooting - Singer SteamLogic Plus 7070 Manual De Instrucciones

PROBLEM
The iron is plugged in but
soleplate is cold.
No steam released.
Steam Burst not working.
No spray mist released.
Soleplate is too cool.
Water leaks from soleplate.
Damage to fabric.
Flakes and impurities come out
of the soleplate holes during
ironing.
This electrical appliance complies with directive 2002/96/EC (Waste Electrical and Electronic
Equipment – WEEE).
The meaning of the crossed-through waste bin symbol on the appliance is the
product must be disposed of separately to other household waste at the end of
the useful life of the appliance. The user is responsible for delivering appliance
to an appropriate collection center at that time.
Appropriate separate collection for environment-friendly treatment and recycling prevents or
reduces harmful effect on the environment and human health. You can obtain information on
available collection services in your area by contacting your local Council waste collection
department, or the retailer from which you bought the appliance.

Troubleshooting

POSSIBLE CAUSE
Electrical outlet does not work.
There is a connection problem.
The temperature setting has been
set to "Low".
Low water in the Water Tank.
Steam Selector is in Steam Off
position.
Low water in the Water Tank.
First time use.
Low water in the Water Tank.
First time use.
Incorrect Temperature Setting.
Steam Iron's heat setting is too low
to produce steam.
Steam Selector is in the 'ON' posi-
tion while refilling Water Tank.
Pressing Steam Burst Button to
many times and too quickly.
Temperature setting is too high.
You have been using hard water,
which has caused scale flakes to
develop inside the soleplate.
SOLUTION
Plug in to another outlet.
Check if the plug is inserted in the outlet
properly.
Set the temperature setting to a higher
temperature.
Fill the Water Tank using instructions
found in this manual.
Turn the Steam Selector to Steam ON
position.
Fill the Water Tank using instructions
found in this manual.
Press the Burst of Steam Button a few
times until Steam Burst is released.
Fill the Water Tank using instructions
found in this manual.
Press the Spray Button a few times until
spray mist is released.
Press Temperature Set Button until you
reach the correct (higher) temperature
setting.
Set temperature setting to Max position
using the Temperature Control Dial.
Turn the Steam Selector to (
before refilling Water Tank.
Press Steam Burst Button slower and
press only 2-3 times.
Follow the garment guide or test the in-
side of the garment before ironing. Adjust
temperature setting accordingly.
Perform Self-Cleaning one or more times.
See "Self-Cleaning" section of this
manual.
) position
ENGLISH – 11