Communication Setup And Test 5.2.7.1 Seral Communication Test; Seral Communication Test Display Setup; Display Setup Bottom Bar Setup - KPS PowerCompact3020 Manual De Usuario

5.2.7.1. Serial communication test
5.2.8. Display setup
hours of operation and the level of brightness selected. Therefore, unless strictly necessary, we advise
against the level of brightness being higher than 70 and keeping the backlight ALWAYS ON.
NOTE: the display turns on automatically i fan alarm goes off.
5.2.9. Bottom bar setup.
Test communication page is helpful when connecting the instrument to
a device to check if communication is correct, as well as to check if the
instrument is working correctly.
This field shows the current status (No communication, Comm. OK)
or the type of error (Cecksum error, framing error, etc.) occurring
during communication.
Return to the "Communication setup" page.
NOTE: in case of a permanent error, check that the parameters have
been configured correctly (PC and instrument)
In the Display Setup it is possible to customize:
backlight time of the display: ON (always on), 15 sec or 1 Min.
LCD display orientation. It may be practical when the instrument
must be placed in a vertical position.
contrast.
brightness.
menú type. Partial menú only displays the main measurements
and not the secondary measurements. It only affects the
displayed information.
language selection: English, Italian, Spanish, French, German.
Obviously, with time, LCD efficiency will depend on the number of
This page allows the user to choose 3 parameters (out of 63) to be
displayed alternately in the bottom part of the measurement screens,
in addition to the battery level. The following parameters are available
:
for visualization
Vrms 3F, Vrms L1, Vrms L2, Vrms L3, Irms 3F, Irms L1, Irms L2, Irms
L3, Prms 3F, Prms L1, Prms L2, Prms L3, Qrms 3F, Qrms L1, Qrms
L2, Qrms L3, Srms 3F, Srms L1, Srms L2, Srms L3, pf 3F", pf L1, pf
L2, pf L3, thdv 3F, thdv L1, thdv L2, thdv L3, thdi 3F, thdi L1, thdi L2,
thdi L3, KWh+3F, KWh L1, KWh L2, KWh L3, KVArh+3F, KVArhL1,
KVArhL2, KVArhL3,
KWh+F3, KWh+F4, Clock, Freq, In, Unbal, n.dip, n.swell, n.int, Vaux,
Iaux, Paux, Qaux, Saux, PFaux, FRaux, CosPhi L1, CosPhi L2,
CosPhi L3.
NOTE: to display only one parameter, select the same parameter for
all 3 options.
- 71 -
KWh-3F, KVArh3F, KWh+F1, KWh+F2,