Construction; Accessories; Unpacking - Hoshizaki FM-1000AKE Manual De Instalación

ENGLISH

1. CONSTRUCTION

2. ACCESSORIES

Air-cooled
CD 1
Mounting Bracket 2
Power Supply Cord 1
Inlet Hose 1
Outlet Hose 1
1/2-3/4 Nipple -
3/8-3/4 Nipple -
Connector Cover 1

3. UNPACKING

Children should not be allowed in reach of the packaging elements (plastic bags and expanded polystyrene) as they are
potential sources of danger.
Do not lift or manoeuvre the carton by using the shipping bands.
When moving the unit by hand, remove the panels and hold the unit frame.
Always wear protective gloves when carrying the unit.
When handling the carton or the unpacked unit, work in pairs to prevent injury.
Remove shipping carton, tape(s) and packing. If packing material is left in the icemaker, it will not work properly.
This icemaker needs a storage bin. The recommended storage bin is HOSHIZAKI
ICE STORAGE BIN, Model B-300SD(PD) or B-500SD(PD) with top kit - 8C,
B-700SD(PD) with top kit - 22C, or B-900SD(PD) with top kit - 22C and top kit -8C.
1) After removing the packaging, make sure that the icemaker and the storage
bin are in good condition. If in doubt, please do not use the icemaker but apply
to professionally qualified personnel. See the instruction sheet attached to the
storage bin for its unpackaging and installation guidelines.
2) Remove the shipping tape holding panels.
3) Remove the front, top, and side panels.
4) Remove the package of accessories. Check the contents according to "2.
ACCESSORIES".
Power Supply Cord
Top Panel
Front Panel
Air Filter
(Air-Cooled Model)
Water-cooled
1
2
CD
1
1
1
1
1
1
Inlet Hose
WARNING
CAUTION
NOTICE
Operation Panel
Louver
Mounting Bracket
Outlet Hose 1/2-3/4 Nipple
Front Panel
Top Panel:
Front Panel: Remove the screw. Lift up and
Side Panel:
2
Power Supply Cord
3/8-3/4 Nipple Connector Cover
Top Panel
Remove the screw. Lift off.
pull toward you.
Remove the screws. Pull slightly
toward you.
Side Panel