Safety Signs; Electric Shock Hazard; Product Identification Label; Main Components - Stiga MH 900 Li 48 Manual De Instrucciones

3.1.4 Type of users
This machine is intended for use by
consumers, i.e. non-professional operators.
It is intended for "hobby-related activities".

3.2 SAFETY SIGNS

The machine has various symbols on
it (fig. 2). Their function is to remind
the operator of the correct conduct for
use, with due care and caution.
Meanings of the symbols:
ATTENTION - DANGER
The failure to use this machine
correctly can be hazardous
for oneself and others.
ATTENTION
Read the owner's manual
before using the machine.
Use safety goggles.
Use hearing protections.
Use thick non-slip
protective gloves.
Do not leave the machine in the
rain (or in damp conditions)
CUTTING HAZARD
Keep hands and feet
away from the blades.

ELECTRIC SHOCK HAZARD

Pay attention to overhead
electrical power lines when cutting.
ATTENTION
Any damaged or illegible decals must
be replaced. Order replacement decals
from an Authorised Service Centre.

3.3 PRODUCT IDENTIFICATION LABEL

The product identification label
provides the following data (fig. 1 ):
1. Sound power level
2. Conformity marking
3. Month/Year of manufacture
4. Type of machine
5. Serial number
6. Name and address of Manufacturer
7. Article code
Write the identification data of the
machine in the specific space on the
label on the back of the cover page.
ATTENTION
State the identification data on the product
identification label whenever you contact
an Authorised Service Centre.
NOTE
An example of the Declaration of Conformity
is provided on the last pages of this manual.

3.4 MAIN COMPONENTS

The machine is composed of a series
of main components that have the
following functions (Fig.1 ):
A. Engine: supplies the drive power
to the cutting means.
B. Commands: these are the
main throttle controls.
C. Rear hand grip: Support hand grip
located on the rear part of the command
rod. It is taken with the right hand.
D. Front hand grip: Support hand
grip located on the command rod.
It is taken with the left hand.
E. Machine support: a piece which, when
attached to the battery backpack, helps
supporting the machine during operation.
F. Connection point: point in which the
machine is attached to the battery backpack.
G. Blade (cutting means): the element
designed to cut the vegetation.
H. Blade protection (for machine
transport and handling): protects against
EN - 6