Storage; Storing; Storing The Battery; Handling And Transport - Stiga HT 900 Li 48 Manual De Instrucciones

Adjustment of the distance between
blades is not necessary, as this is
predetermined by the manufacturer.
8.1.2 Sharpening
It is necessary to sharpen the blades when
the trimming performance decreases and
the branches tend to stick together.
DANGER
For safety reasons, sharpening should be
performed by an Authorised Service Centre
with suitable skills and equipment for the
job, without risking any damage to the blade
which would make it unsafe when used.
ATTENTION
Always replace and never repair a blade
which has blunt cutting edges.
8.1.3 Replacement
ATTENTION
The blade must never be repaired, but must
be replaced as soon as signs of breaking are
noted or the sharpening limit is exceeded.
For safety reasons replacements should be
performed by an Authorised Service Centre.
Blades displaying the code indicated
on the Technical Data table should
be used on this machine.
Given product evolution, the blades listed
in the "Technical Data" table may be
replaced in time with others having similar
interchangeable and operating safety features.

9. STORAGE

DANGER
The safety rules to be followed during
storage operations are described at
par. 2. Strictly observe these indications
to avoid serious risks or dangers.

9.1 STORING

When the machine is to be stored away:
1. Disconnect the machine from
the battery backpack;
2. Remove the battery from its
compartment and recharge it;
3. apply the guard to the blade.
4. Wait until the engine has
properly cooled down;
5. Clean (para. 7.3);
6. make sure there are no loose
or damaged components;
7. if necessary, replace the damaged
components and tighten any
screws and loose bolts or contact
the authorised service centre.
8. Store the machine:
• in a dry place;
• protected from inclement weather;
• in a place out of children's reach;
• making sure that keys or tools used
for maintenance are removed.

9.2 STORING THE BATTERY

The battery must be kept in a cool,
shaded place without humidity.
NOTE
In case of prolonged inactivity,
recharge the battery every two months
to prolong its service life.

10. HANDLING AND TRANSPORT

Whenever the machine is to be
handled or transported you must:
1. stop the machine (para. 6.5);
2. remove the battery from its housing
and recharge it (par. 7.2.2);
3. when the cutting means has
halted, fit the blade guard;
4. wear protective work gloves;
5. only hold the machine using the
hand grips and position the cutting
means in the opposite direction to
that used during operations.
When transporting the machine
on a vehicle, always:
• Properly secure the machine;
• position it so that it does not
cause a hazard to anyone.

11. ASSISTANCE AND REPAIRS

This manual provides
all the necessary
information to run the
EN - 12
machine and for correct
basic maintenance
operations which