Product Identification Label; Main Components; Assembly - Stiga HT 900 Li 48 Manual De Instrucciones

Use thick non-slip
protective gloves.
Do not leave the machine in the
rain (or in damp conditions)
CUTTING HAZARD
Keep hands and feet
away from the blades.
Class II
Dual insulation
ATTENTION
Any damaged or illegible decals must
be replaced. Order replacement decals
from an Authorised Service Centre.

3.3 PRODUCT IDENTIFICATION LABEL

The product identification label
provides the following data (fig. 1 ):
3. CE conformity marking
4. Name and address of Manufacturer
5. Sound power level
6. Article code
7. Type of machine
8. Serial number
9. Year of manufacture
Write the identification data of the
machine in the specific space on the
label on the back of the cover page.
ATTENTION
State the identification data on the product
identification label whenever you contact
an Authorised Service Centre.
NOTE
An example of the Declaration of Conformity
is provided on the last pages of this manual.

3.4 MAIN COMPONENTS

The machine is composed of a series
of main components that have the
following functions (Fig.1 ):
A. Engine: supplies the drive power
to the cutting means.
B. Blade (cutting means): the element
designed to cut the vegetation.
C. Front hand grip: used to handle the
machine and equipped with the safety switch.
D. Rear hand grip: used to handle the machine
and equipped with the main control buttons.
E. Blade protection (for machine
transport and handling): protects against
accidental contact with the cutting
means that can cause serious injuries.
Battery backpack (attachment
F.
on request, par. 15.3): device in
which the batteries are placed.
G. Battery (attachment on request,
par. 15.1): device that supplies
electric current to the tool.
H. Battery charger (attachment on request,
par. 15.2): device used to recharge the
battery; its specifications and regulations
for use are described in a specific manual.
Three battery charger models are available:
H1 (fast battery charge); H2 (standard
battery charge); H3 (dual battery charge).
I. Connection cable: cable used to connect
the machine to the battery backpack.

4. ASSEMBLY

DANGER
The safety regulations to be followed are
described in chapter 2. Strictly comply with these
instructions to avoid serious risks or hazards.
For storage and transport purposes, some
components of the machine are not installed
directly in the factory and have to be assembled
after unpacking. Follow the instructions below.
ATTENTION
Unpacking and completing the assembly
should be done on a flat and stable surface,
with enough space for moving the machine
and its packaging, always making use of
suitable equipment. Do not use the machine
until all the instructions provided in the
"ASSEMBLY" section have been carried out.
EN - 6