Non Fading Output Level Adjustment; High Pass Filter (Hpf); Front Image Enhancer Function (Fie) - Pioneer Super Tuner III MEH-P7150 Manual De Operación

Audio Adjustment
Non Fading Output Level Adjustment (NonFad)
When the Non Fading output is ON, you can adjust the level of Non Fading output.
1. Press the AUDIO button and select the Non Fading Output setting mode
(NonFad) in the Audio Menu.
2. Increase or decrease the output
level with the 5/∞ buttons.
The display shows "0" – "–15".
Note:
• You can select the Non Fading Output setting mode only when Non Fading output is switched ON
in the Non Fading Output ON/OFF mode.

High Pass Filter (HPF)

When you do not want sound in the Subwoofer output frequency range output from the
front or rear speakers, switch the High Pass Filter ON. Only higher frequencies than those
in the selected range are output from the front and rear speakers.
1. Press the AUDIO button and select the H.P.F. mode (HPF) in the Audio
Menu.
2. Switch the H.P.F. function
ON/OFF with the 5/∞ buttons.
3. Select the desired frequency
with the 2/3 buttons.
50 + = 80 + = 125 (Hz)
Note:
• When the F.I.E. function is ON, you cannot switch to the H.P.F. mode.

Front Image Enhancer Function (FIE)

The F.I.E. (Front Image Enhancer) function is a simple method of enhancing front imag-
ing by cutting mid- and high-range frequency output from the rear speakers, limiting their
output to low-range frequencies. You can select the frequency you want to cut.
Precaution:
• When the F.I.E. function is deactivated, the rear speakers output sound of all frequencies, not
just bass sounds. Reduce the volume before disengaging F.I.E. to prevent a sudden increase in
volume.
33