Setting The Dimmer (Dim); Selecting The Brightness (Bright); Setting The Rear Speaker Lead And - Pioneer Super Tuner III MEH-P7150 Manual De Operación

Initial Setting

Setting the Dimmer (DIM)

To enable this product's display from being too bright at night, when the vehicle's head
lights are turned ON the display is dimmed.
You can switch this function ON/OFF.
1. Press the FUNCTION button and select the Dimmer mode (DIM) in the
Initial Setting Menu.
2. Switch the Dimmer ON/OFF
with the 5/∞ buttons.

Selecting the Brightness (BRIGHT)

You can select the display brightness. Initially this mode is set to 12. The display shows
"0" – "15".
1. Press the FUNCTION button and select the Brightness mode (BRIGHT) in
the Initial Setting Menu.
2. Select the desired Brightness
with the 2/3 buttons.
Setting the Rear Speaker Lead and Subwoofer Controller (SW)
This product's rear speaker leads can be used for full-range speaker ("Rear SP:FULL") or
Subwoofer ("Rear SP:S.W") connection. If you switch Rear Speaker Lead setting to the
"Rear SP:S.W", you can connect a rear speaker lead directly to a Subwoofer without using
an auxiliary amp.
Initially, the unit is set for rear full-range speaker connection ("Rear SP:FULL").
When rear speaker leads are connected to full range speakers (when "Rear SP:FULL" is
selected), you can connect the RCA Subwoofer output to a Subwoofer. In this case, you
can select whether to use the Subwoofer controller's (Low Pass Filter, Phase) built-in
"S.W Control:INT" or the auxiliary "S.W Control:EXT".
Note:
• Even if you change this setting, there is no output unless you switch the Non Fading Output (refer
to page 32) or Subwoofer Output (refer to page 31) in the Audio Menu ON.
• If you change the Subwoofer Controller, Subwoofer output and Non Fading output in the Audio
Menu return to the factory settings.
39