Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Audio Adjustments
Adjusting subwoofer settings
When the subwoofer output is on, you can
adjust the cut-off frequency and the output level
of the subwoofer.
1 Press
to select the
AUDIO
When the subwoofer output is on, you can
select the
. Press
Sub-W2
(Hz) appears in the display.
• If the subwoofer setting has been previously
adjusted, the frequency of that previously
selected will be displayed, such as
(Hz).
2 Press 2 or 3 to select cut-off frequency.
Press 2 and
(Hz) is displayed. Press 3 and
50
(Hz) is displayed. Only frequencies lower
125
than those in the selected range are output
from the subwoofer.
3 Press 5 or ∞ to adjust the output level of
the subwoofer.
Each press of 5 or ∞ increases or decreases
the level of the subwoofer (e.g.,
Press 5 or ∞ until you see the desired value
displayed.
.
Sub-W2
until
AUDIO
Sub-W2 80
(Hz) or
50
125
to
).
+6
–6
Using non fading output
When the non fading output setting is on, the
audio signal does not pass through this unit's
low pass filter (for the subwoofer), but is output
through the RCA output.
1 Press
to select non fading output
AUDIO
on/off mode.
When the subwoofer controller setting is
, you can select non fading output
Control:EXT
on/off mode. Press
AUDIO
appears in the display.
2 Press 5 to turn non fading output on.
appears in the display. non fading
NonFad ON
output is now on.
• You can turn off non fading output by pressing
∞.
Adjusting non fading output level
When the non fading output is on, you can
adjust the level of non fading output.
1 Press
to select non fading output
AUDIO
setting mode.
Press
until
AUDIO
NonFad 0
play.
2 Press 5 or ∞ to adjust the output level of
the non fading.
Each press of 5 or ∞ increases or decreases
the level of the non fading (e.g.,
Press 5 or ∞ until you see the desired value
displayed.
Section
S.W
until
NonFad ON
appears in the dis-
to
).
+6
–6
En
07
33
Publicidad
Capítulos
Tabla de contenido
