Temperature Setting; Electrical Connection - Dometic MaCave A192G Instrucciones De Uso

1. Remove the transport pallet on which your
wine cellar rests.
2. Adjust the feet to allow a 30 mm (1.2")
clearance under the wine cellar and verify
that it stands in a vertical position in both
directions. If necessary, use a spirit level.
3. Check that the charcoal filter is in place at
the top left corner inside the wine cellar.

electrIcal connectIon

The electrical installation must be carried out cor-
rectly, taking into account all relevant regulations
and codes of practice.
The wine cellar operates on a single-phased
alternating current.
Please check that the voltage shown on the data
plate corresponds to your power supply.
The wine cellar is fitted with a plug intended for a
grounded socket. Dometic and its subsidiaries will
not be held responsible for any incident due to non-
existent or defective ground wires.
Electrical leads must be routed and secured so
that they cannot come into contact with hot or
sharp parts of the wine cellar.
!
Warning
the wine cellar must be grounded.

temperature settIng

The wine cellar is equipped with an electronic
control. This allows you to program the tempera-
ture inside the wine cellar. Your wine will be stored
between 10 °C (50 °F) and 15 °C (59 °F) according
to expert advice.
The temperature, pre-set in the factory, is shown
on the display. The temperature, pre-set at
12 °C (54 °F), can be changed on demand between
8 °C (46 °F) and 18 °C (64 °F) depending on the
wine stored.
1. Plug in the wine cellar and turn it on with
the ON/OFF switch.
0
1
2. Press and hold the UP
arrow button for a few seconds until the
display starts blinking.
3. Release the button. Press the UP/DOWN
arrow buttons to set the temperature.
The new value is saved automatically after
6 seconds.
A certain smell may be noticeable when
using the wine cellar for the first time.
This will disappear after a few hours.
- 4 -
▲
▼
( )
( )
or DOWN