Temperature Setting - Dometic CS 110 Manual Del Usuario

temperature settIng

Plug in the wine cellar and turn it on with the ON/
OFF switch.
The wine cellar is equipped with an electronic
control. This allows you to program the tempera-
ture inside the wine cellar. Your wine will be stored
between 50 F (10°C) and 59 F (15°C) according to
expert advice. The temperature, pre-set in the fac-
tory, is shown on the display.
The temperature, pre-set at 54 F (12°C), can be
changed on demand between 46 F (8°C) and 64 F
(18°C) depending on the wine stored.
1. Press and hold the UP
arrow button for a few seconds until the
display starts blinking.
2. release the button. Press the UP/DOWN
arrow buttons to set the temperature.
The new value is saved automatically after
6 seconds.
EN
maIntenance
We recommend that you keep your wine cellar as
clean as possible. Unplug the cellar before clean-
ing. Do not use any abrasive or strong scented
substances. Use a smooth cloth or sponge and light
detergent.
It is very important to check regularly that the air
circulation underneath and behind the cellar is not
blocked.
Condensation collects in a small cup placed at
the back of the wine cellar. The cup has a sponge
which helps the condensation to evaporate. Check
that the plastic pipe routing the water from the
inside to the cup is not blocked by dust or dirt.
You should replace the inside ventilation charcoal
filter every second year. The filter is fitted in the
upper left corner inside the wine cellar.
( )
( ▲ ) or DOWN
▼
If the wine cellar fails to work, check the following
points before calling a service technician:
If the cause of failure is not to be found among the
points listed above, contact an authorised service
technician.
The wine cellar is equipped with an overheating
protection. An authorised service technician can
check whether this has been triggered or not.
- 5 -
• Is the fuse of power supply intact?
• Is the plug properly inserted in its socket?
• Is the wine cellar switched on?