Sharp MX-B350W Guía De Inicio página 10

(5) Close the auxiliary tray and then the bypass
tray, grasp the side cover open/close
handle, and gently open and close the side
cover.
The message " Clear paper path." will be cleared and
copying will be possible.
MACHINE
To remove a misfeed from inside the machine, open the
side cover, check whether the misfeed occurred in "A",
"B", or "C" below, and follow the misfeed removal
procedure.
Area B
Area A
Misfeed in the paper feed area A
(1) Carefully remove the misfed paper. Turn
the roller rotating knob in the direction of
the arrow to assist in removing it.
Be careful not to tear the misfed paper during removal.
The fusing unit is hot. Do not touch the fusing unit when
removing misfed paper. Doing so may cause a burn or injury.
Roller rotating knob
8
Area C
Fusing unit
(2) Close the side cover.
The message " Clear paper path." will be cleared and
copying will be possible.
Misfeed in the paper feed area B
(1) Lift the fusing unit pressure adjusting
levers to allow easier removal.
Fusing unit pressure adjusting levers
(2) Remove the misfed paper.
Be careful not to tear the misfed paper during removal.
The fusing unit is hot. Do not touch the fusing unit when
removing misfed paper. Doing so may cause a burn or
injury.
(3) If the misfed paper cannot be removed,
remove the paper by pulling it into the
paper output area.
(4) Lower the fusing unit pressure adjusting
levers, to return them to their operating
positions.
(5) Close the side cover.
The message " Clear paper path." will be cleared and
copying will be possible.