Positioning The Vertical Rod; Mounting Of The Bead Breaking Cylinder - Sicam COLIBRI BL512 26 ITAS Manual Original

4.2.4

Positioning the vertical rod

1. Use the locking lever to unlock the vertical rod (1),
lift by about 10 cm and block it again.
2. Unscrew the cap on top of the rod with a wrench
(2).
2
1
!
Warning: when unlocking the rod keep a hand under-
neath it.
3. Remove the rod; remove the spring and put again the
rod in its original seat, locking it at the end stop.
4. Insert the spring in the upper part of the rod and
screw again the cap with the wrench.
Sicam srl società unipersonale
Initial commissioning | COLIBRI BL512 26" ITAS | 25
Danger!
The spring could eject violently the rod from
its housing, thus it might be a serious danger
for the operator.
€
Carry out this operation carefully.
4.2.5

Mounting of the bead breaking cylinder

1. Remove the external elastic ring and take off the hin-
ge rod from its housing in the bead breaking arm.
2. Insert the bead breaking arm and centre the joint
pin.
3. Insert the hinge-pin and put back in place the exter-
nal elastic ring.
4. Place the buffer spring on the provided tab and
screw in the bead breaking cylinder the self locking
nut.
Danger!
Wrong mounting of the bead breaking cylin-
der compromises machine functioning and
can be a serious danger for the operator.
€
During machine installation be sure that
the nut is correctly screwed in the bead
breaking cylinder rod (at least 10 mm).
en
|
105 890 2010-11-08