Hayward AQUA RITE pro Guia Del Usuario página 25

The AquaRite Pro is an automatic chlorine generation system for pool or spa sanitization. The
operation requires a low concentration of salt (sodium chloride) in the pool water. These levels
are low enough that it normally will not be tasted. The AquaRite Pro automatically sanitizes
your pool by converting the salt into free chlorine which kills bacteria and algae in the pool.
Chlorine will revert back to sodium chloride after killing bacteria. These reactions will continu-
ously recycle virtually eliminating the need to add sanitizing chemicals to your pool. The only
time you may need to add more salt to the pool is when water is replenished due to backwashing,
draining, or splashing (not evaporation).
The AquaRite Pro is designed to handle the purification needs of most residential swimming
pools up to 150 m
3
other restrictions. The actual amount of chlorination required to properly sanitize a pool varies
due to bather load, rainfall, temperature, and the pool's cleanliness.
AquaRite Pro chlorine generators operating with software version 1.00 or later are designed to
use one of 3 different chlorinator cells that are available from your authorized Hayward dealer.
Choose the appropriate cell based on the size of your pool. The models are shown below:
T-CELL-15-E - for pools up to 150 m
T-CELL-9-E - for pools up to 95 m
T-CELL-3-E - for pools up to 60 m
Note that the installation and mounting requirements are the same for all models.
The AquaRite Pro can be used with the optional Goldline AQL-CHEM to provide a fully in-
tegrated chemistry solution for your pool. With the AQL-CHEM installed, the AquaRite Pro
senses the pool's ORP and pH levels and automatically generates the correct amount of chlorine
to keep your pool properly sanitized. The AquaRite Pro can also control pH by introducing acid
into the pool when needed. A dedicated on/off control output is available for pH dispensing
devices using 230 V. The AquaRite Pro and AQL-CHEM products offer the user a complete
automated system controlling both sanitization and pH balance.
NOTE: It is not recommended to use the AquaRite Pro to generate bromine.
NOTE: Before installing this product as part of a saline water purification system in a pool or
spa using natural stone for coping or for immediately adjacent patios/decking, a qualified stone
installation specialist should be consulted regarding the appropriate type, installation, sealant
(if any) and maintenance of stone used around a saline pool with electronic chlorine generator
in your particular location and circumstances.
1 / 20
OPERATION
, or the needs of most commercial pools up to 95 m
3
3
3
AquaRite Pro
. Check local codes for
3
Rev. C