Settings Menu - Hayward AQUA RITE pro Guia Del Usuario

Check System
Low Salt
Refer to the Troubleshooting section for information about error conditions
and possible causes.

Settings Menu

The Settings Menu is used to configure the AquaRite Pro and adjust various settings. Access
this menu by pushing the Settings Menu button. Refer to the information below when setting
system operating parameters.
To access the Settings Menu
Setting
Menu - Locked
Setting
Menu - Unlocked
NOTE: To prevent unauthorized access, the settings menu automatically
"locks" after 2 minutes of no buttons being pressed.
Language
English
Language
The AquaRite Pro can display the following languages: English (default),
French, Spanish, Italian, German, Portuguese and Dutch. Select the desired
language.
Chlor. Config.
+ to view/change
Body of Water Type
Pools
Display
Salt
Cell Type
T-CELL-15
Body of Water Type
Select Pool or Spa. "Pool" should be selected for bodies of water over 4 M
The AquaRite Pro will adjust its operation according to this selection.
Display
Allows for the display of salt (default) or mineral values.
Cell Type Selection
Make the proper selection based on the electrolytic cell that is used in your
system. Selections are: T-CELL-3, T-CELL-9 and T-CELL-15 (default).
Note that the unit will not function properly if the wrong cell is selected
9 / 20
Function depends on displayed menu item
Move to next Check System condition or previous/next menu item
Press BOTH buttons SIMULTANEOUSLy for 5 seconds to unlock
Move to settings menus
Rotates between available languages
Move to previous/next settings menu
Push to access Chlorinator option
Move to previous/next menu item
Toggle between Pool and Spa
Move to next menu item
Toggle between Salt (default) and Minerals
Move to next menu item
Toggle between available cell types
Move to previous/next menu item
AquaRite Pro
.
3
Rev. C