Key Beep; Language; Resetting To Factory Defaults; Simulate Mode - Navman FISH450 Tricolor Manual De Instalación Y Funcionamiento

4-7 Key Beep

The Key Beep function is located on the Setup menu.
It allows the user to activate an audible beep each
time a key is pressed.
Pressing the Cursor Right key when the word Key
Beep is highlighted switches between On and Off.

4-9 Resetting to factory defaults

All settings may be reset to the
manufacturer 's
settings. (See right.)
IMPORTANT: Resetting to
factory defaults will erase all
settings you have made except
fuel used (Used) and fuel
remaining (Remaining).
To enter the Default Set
screen, first power off.
Hold the Cursor Left key down
and power on while continuing
to hold it down.
The message "RESET TO
FACTORY DEFAULTS?" will
appear.
Use the Cursor Left and Right
key to switch between Yes and
No, then press the Menu key
to continue the power on
sequence.
4-10 Simulate
An internal simulator allows users to familiarise
themselves with operating the FISH450 Tricolor
off the water. When in Simulate mode the word
"Simulate" flashes on the bottom of the screen.
When in Simulate the unit generates data so that
all the main screens appear operational. Any
changes made to the backlighting, alarms and
display setup are saved, but the fuel log (Used)
NAVMAN
FISH450 Tricolor FISHFINDER Installation and Operation Manual
GENERAL
defaults
Auto Gain ................................ON
Auto Range ..............................ON
Manual Gain ...............................5
Bottom Lock ..........................OFF
Key Beep ...............................OFF
UNITS
Temperature .............................°C
Depth ..................................Metres
Speed ....................................KTS
Fuel ......................................Litres
ALARMS
Shallow Alarm .......................OFF
Shallow Alarm Value ............3.0 m
Deep Alarm ...........................OFF
Deep Alarm Value .............20.0 m
Fish Alarm .............................OFF
Fuel Alarm .............................OFF
Fuel Alarm Value ..............20 litres
Temp. Change Alarm ............OFF
Temp. Change Alm Val. ......2.0 °C

4-8 Language

Access the Language
screen through the Setup
menu.
To select a language, press
the Cursor Up or Down key
to highlight it, then press
the Menu key to save and
exit.
Temp. Alarm .......................OFF
Temp. Alarm Value ........25.5 °C
Low Battery Alarm ...............ON
Battery Alarm Value ...11.5 Volts
DISPLAY
Fish Symbol ...................
Speed Display .....................ON
Temperature Display ..........OFF
Display Cal ..............................9
Red Cal ...................................3
Blue Cal ...................................3
Backlight ..................................6
FUEL
Tank Size ......................70 litres
Num Engines ...........................0
Flow Filter .....................10 secs
OTHER
Keel Offset .......................0.0 m
Logs ............................ Trip Log
Language ..................ENGLISH
and fuel remaining (Remaining) are not affected.
To turn the Simulate mode on, power the unit off,
disconnect the blue transducer plug at the rear of
unit, then power the unit on.
To turn the Simulate mode off, power the unit off;
reconnect the blue transducer plug at the rear of
unit, then power the unit on.
17