Publicidad
5000800a_RET_REO_032008:6
Contents
CE-Declaration of conformity
We declare under our sole responsibility that this product is in
compliance with the regulations 2006/95/EC and 2004/108/EC
and conforms to the standards or standardized documents DIN EN
IEC 61010-1, -2-010 and DIN EN IEC 61326-1.
14
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
23.06.2008
16:26 Uhr
Seite 14
Safety instructions
EN
Page
14
• Read the operating instructions in full before starting up and
14
16
• Keep the operating instructions in a place where they can be
16
17
• Ensure that only trained staff work with the appliance.
18
• Follow the safety instructions, guidelines, occupational health
18
• Socket must be earthed (protective ground contact).
19
• Caution - Magnetism! Effects of the magnetic field have to be
19
• Risk of burns! Exercise caution when touching the housing parts and
20
20
21
• Ensure that the mains power supply cable does not touch the
22
23
• Wear your personal protective equipment in accordance with the
• Set up the appliance in a spacious area on an even, stable, clean,
• The feet of the appliance must be clean and undamaged.
• Check the appliance and accessories beforehand for damage
• Gradually increase the speed.
• Reduce the speed if
• Caution! Never process and heat up any media that has a flash
For your protection
follow the safety instructions.
accessed by everyone.
and safety and accident prevention regulations.
taken into account (e.g. data storage media, cardiac pacemakers ...).
the heating plate. The heating plate can reach temperatures in excess
of 340 °C. Pay attention to the residual heat after switching off.
heating base plate.
hazard category of the media to be processed. Otherwise there
is a risk from:
- splashing and evaporation of liquids
- ejection of parts
- release of toxic or combustable gases.
non-slip, dry and fireproof surface.
each time you use them. Do not use damaged components.
- the medium splashes out of the vessel because the speed is too high
- the appliance is not running smoothly
- the container moves on the base plate.
point higher than the adjusted safe temperature limit that has
been set (50 to 360 °C).
032008
Publicidad
Capítulos
