Publicidad
5000800a_RET_REO_032008:6
Operation
Ensure that the protective film is removed from the base plate before use!
Commissioning
Stirring
i
Heating
Connecting
external
thermometers
(direct temper-
ature control in
the media)
032008
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
23.06.2008
16:26 Uhr
Seite 17
REO basic
Move device switch (A) to the OFF position
Insert the mains power cable into the power socket (K)
Move device switch (A) to the ON position
¢
Operating mode B is preset
Adjust the motor speed using the rotary knob (D)
¢
The value selected will be shown on the display (F)
Set the start point for the agitation function by pressing the rotary knob (D)
¢
The displayed value will flash until the desired motor speed is reached
RET basic safety control
¢
Operating mode A is preset (see "Operating modes")
Set the safe temperature limit (see "Setting the safe temperature limit for RET")
Adjust the set-point temperature using the rotary knob (C)
The value selected will be shown on the display (E)
Set the temperature control mode (see "Setting the temperature control mode for RET")
Set the start point for the heating function by pressing the rotary knob (C)
The set-point and actual temperatures will be shown alternately on the display (E)
i
When the heating is switched on, the LED "Heating plate" (G) and the LED "Set-point value" (I)
will be lit.
The maximum temperature that can be set for the heating plate is 310 °C
During agitation and standby operation, the display (E) will show
i
is above 50 °C.
Move device switch (A) to the OFF position
Detach contact plug (L)
Attach a DIN 12878 (Class 2) compliant safety contact thermometer or a
PT 1000 temperature sensor to the socket (L)
Move device switch (A) to the ON position
Temperature sensor PT 1000 The actual temperature for the temperature sensor shown on
i
Contact thermometer e.g. ETS-D5
Follow the operating instructions for the contact thermometer
i
The LED "decimal point for the temperature display" (J) will be lit
When a contact thermometer is connected, the display (E)
will only show the set-point temperature that has been set
if the base plate temperature
HOt
display (E) will correspond to the temperature of the media.
The LED "external temperature sensor" (H) will be lit
17
Publicidad
Capítulos
