Bosch 5312 Instrucciones De Funcionamiento Y Seguridad página 2

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

_
"READ ALL INSTRUCTIONS" -- Failure to follow the SAFETY RULES identified by
__
BULLET (o)symbol listed BELOW and other safety precautions, may result in serious
personal injury.
General
Safety
Rules For Bench
Top Tools
Work Area
• Do not abuse the cord. Never use the cord to
• Keep work
area clean and well
lit.
Cluttered
benches and dark areas invite acdents.
• Do not operate
power tools
in explosive
at-
mospheres,
such as in the presence
of flam-
mable
liquids,
gases
or dust.
Power tools
create sparks which may ignite the dust or fumes.
• Keep bystanders,
children
and visitors
away
while
operating
a power tool.
Distractions
ca-
cause you to lose control.
• Store idle tools
out of reach of children
and
other untrained
persons.
Tools are danger-ous
in the hands of untrained users.
• Do not leave tool running unattended, turn
power off. Do not leave tool until it comes to
acomplete stop.
• MAKE WORKSHOP CHILDPROOF with pad
lock, master switches, or by removing starter
keys.
Electrical
Safety
• Before
plugging in the tool, be certain
the out-
let voltage
supplied
is compatible
with
the
voltage
marked
on the nameplate
within
10%.
An outlet voltage incompatible
with that specified
on the nameplate
can result in serious
hazards
and damage to the tool.
• Double insulated tools are equipped with a po-
.
larized
plug
(one
blade
is wider
than
the
other).
This plug will fit in a polarized
outlet
only one way. if the plug does not fit fully
in
the outlet,
reverse
the plug.
if it still does not
fit, contact
a qualified
electrician
to install a
"
polarized
outlet.
Do not change
the plug in
any way. Double insulation
eliminates
the need
for the three
wire grounded
power
cord
and
grounded
power supply.
• Avoid
body contact
with
grounded
surfaces
such as pipes, radiators,
ranges and refriger-
ators.
There is an increased risk of electric shock
if your body is grounded.
• Do not expose power tools to rain or wet con-
"
ditions.
Water entering a power tool will increase
the risk of electric shock.
"SAVE
THESE
carry the tools or pull the plug from an outlet.
Keep cord away from heat, oil, sharp edges or
moving
parts.
Replace damaged
cords imme-
diately.
Damaged cords increase the risk of elec-
tric shock.
When operating a power tool outside, use an
outdoor extension cord marked "W-A" or "W".
These cords are rated for outdoor use and reduce
the risk of electric shock.
Personal Safety
• Stay alert, watch what you are doing and use
common sense when operating a power tool.
A moment of inattention or use of drugs, alcohol
or medication while operating power tools can be
dangerous.
• Dress properly. Do not wear loose clothing or
jewelry.
Contain long hair. Keep your hair,
clothing and gloves away from moving parts.
Loose clothes, jewelry or long hair can be caught
in moving parts. Roll long sleeves above elbows.
Rubber gloves and non-skidfootwear are recom-
mended when working outdoors.
• Avoid accidental starting. Be sure switch is
"OFF" before plugging in. Carrying tools with
your finger on the switch or plugging in tools that
have the switch "ON" invites accidents.
Remove adjusting
keys or wrenches before
turning the tool "ON". A wrench or a key that is
left attached to a rotating part of the tool will be
thrown.
Do not overreach, keep proper footing and
balance at all times. Proper footing and balance
enables better control of the tool in unex-pected
situations.
Do not stand on tool or its stand. Serious injury
may occur if the tool is tipped or if the cutting tool
is accidentally contacted. Do not store materials
on or near the tool such that it is necessary to
stand on the tool or its stand to reach them.
Use safety equipment.
Always wear safety
goggles.
Dust mask, safety shoes, hard hat or
hearing protection must be used for appropriate
INSTRUCTIONS"
-2-

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

5412

Tabla de contenido