Assembly - Bosch 5312 Instrucciones De Funcionamiento Y Seguridad

ToolsNeeded For
Assembly And Alignment
Combination Square Hex "L" Wrench Multi Purpose "L" Wrench 6.5ram
(suppmied) 1.5ram (suppmied with modem 5312 onmy)
Combination Square Must be True
Draw Light Straight Edge of Board 3/4"
Line on Board Thick This Edge Must be
Amongthis Edge _" ,r_ Perfectmy Straight
..oo,00oooo 0o ovo ,a0
when Square is Flipped Over I _'_i
in Dotted Position J
Multi Purpose Tool (supplied
with model 5412 only)
10mm/17mm Combination
Open End Wrench
_ Disconnect plug from power source before performing any assembly, adjustment or repair
__ to avoid possible injury.
Unpacking And Checking Contents
_ efore moving the saw: Lock the
miter lock knob in 45° position.
Lock bevel lock handle. Pull the head assembly com-
pletely toward you and tighten the slide rail lock knob.
Lock head assembly in the down position.
Never carry the tool by the slide rails, this may
cause blade damage.
Never carry the tool by the cord or head assembly
power switch handle. Damage to insulation could
cause an electric shock. Damage to wire connec-
tions could cause a fire.
Models5312 & 5412 MiterSaws are shipped complete
in one box.
1. Separate all parts from packing materials and
check each one with the "Table of Loose Parts" to
make sure all items are accounted for before
discarding any packing material.
2. Table of Loose Parts:
Quick-Action Clamp (Model 5412 only) - Used to
clamp workpieces.
Workpiece Clamp (Model 5312 only) - Used to
clamp workpieces.
Dust Elbow/Dust Bag - Used to collect saw dust.
Multi Purpose Tool (Model 5412 only) - Should
be stored on the right rear base.
Rear Cord Wrap, washer and Screw - Used for
wrapping the cord
-10-
Miter Lock Knob - Used to lock the table at de
sired miter angle.
lf any parts are missing, do not
__ plug in power cord or turn the
switch on until the missing parts are obtained and
are installed correctly.
Attaching Miter Lock Knob
Locate the miter gauge lock knob from among the
loose parts, and thread shaft on lock knob into hole
provided.
Miter Gauge
Lock Knob
Attaching Rear Cord Wrap
Locate the rear cord wrap from among the loose
parts, position rear cord wrap as shown and secure
with washer and phillips screw provided.
Rear Cord Wrap