Bosch 5312 Instrucciones De Funcionamiento Y Seguridad página 30

CrownMolding
Angled to Table and Fence
The preferred method for cutting crown molding with
this saw is with the molding laying fiat on the table.
• The advantage to cutting moldings angled against
fence is that no bevel setting is required. Only the
miter angle is adjusted.
• The maximum crown molding width that can be cut
and angled to table and fence is 6".
• When cutting crown molding in this fashion it is
recommended to purchase and use the optional
MS 1221 Horizontal Clamp and Crown Molding
Stop Accessory.
Follow these instructions for cutting
crown molding angled to table and fence,
1. Position the molding so the bottom (decorative
part, which is installed against the wall)is against
the fence.
2. For 90 ° corner, set the miter angle using Chart
below. Tighten the miter lock knob (Figure 36).
3. Support crown molding against the fence (see
"Body and Hand Position" on page 19.)
4. Follow the procedures for chop or slide cut (see
page 23).
5. Wait until blade comes to a complete stop before
returning head assembly to the raised position
and/or removing workpiece.
NOTE: ALWAYS TAKE A TEST CUT USING
SCRAP TO CONFIRM CORRECT ANGLES,
Crown Molding Angled __
L--- 45 ° Miter --J
Figure 36. Crown Molding Angled to
Table and Fence
Miter and Bevel Settings for Standard Crown Molding Cuts
(When Workpiece Angled Against Fence)
Assumptions: Molding is milled consistently.
• Corner is 90 degrees.
• For other corner angles, divide actual measure-
ment by 2.
For any Crown Molding
Miter Bevel
(Table) (Tilt)
Setting Setting
inside Corner
Left end (A) (45) Right 0 Left
Use the right end
of the cut
Right end (B) (45) Left 0 Right
Use the left end
of the cut
Outside Corner
Left end (C) (45) Left 0 Right
Use the right end
of the cut
Right end (D) (45) Right 0 Left
Use the left end
of the cut
-30-