Autolearning Of The Travel Stroke - Key Automation CT202 Instrucciones Y Advertencias Para Su Instalación Y Uso

EN
Malfunctions
This section lists a number of malfunctions which may occur.
SURGE OVERLOAD ALARM
EFO
SAFETY EDGE ALARM
EED
PHOTOCELL ALARM
EPH
ELECTRONIC OVERLOAD CUTOUT
TRIPPED
Eth
After eliminating the cause of the alarm, to delete all errors simply
press the "DOWN -" key or press the SS (STEPPING) command

4.3 - Autolearning of the travel stroke

The first time the control unit is powered up, an autolearning proce-
dure must be carried out to acquire fundamental parameters such
as the travel stroke length and deceleration points.
Press the + or - keys to view not only the status of the control unit, as
AUTOLEARNING OF THE TRAVEL STROKE AND MAIN PARAMETERS, WITH
PRESET DECELERATIONS
The deceleration intervals are as set in the menu, with the same percentage applied during opening and
closing.
CAUTION: if manual programming of deceleration intervals is required, go to the next table
1. CAUTION! check that mechanical end stops (compulsory) are present and secure. The motors must
always reach the mechanical end stop
2. Move the gate manually to mid-travel.
3. Press the pushbuttons UP + and MENU at the same time for at least 5 seconds until LOP is displayed, then
(if necessary) press DOWN (see figure).
Ensure that motor M1 is activated first; otherwise, press DOWN -, turn the power off and invert connections
M1 and M2. Repeat the procedure from step 3.
If the first manoeuvre is NOT opening, press DOWN - to stop the self-learning process. Then press SS to
restart acquisition: the leaf resumes movement in the correct direction.
4. Motor M1 opens at low speed until it reaches the mechanical opening end stop.
At precisely the time of reaching the mechanical opening end stop, press the SS command.
Motor M2 starts automatically in opening mode. If motor M2 moves in closing, stop by pressing DOWN - and
resume movement using SS (the leaf resumes movement in the correct direction)
5. Motor M2 opens at low speed. At precisely the time of reaching the mechanical opening end stop,
press the SS command. After a couple of seconds, motor M2 starts automatically in closing at full speed.
6. Precisely when motor M2 reaches the closed position, press the SS command. Motor M2 stops and
motor M1 starts in closing.
7. Precisely when motor M1 reaches the closed position, press the SS command. Motor M1 stops and
restarts in opening.
8. Precisely when motor M1 reaches the open position, press the SS command. Motor M1 stops and
motor M2 starts in opening.
9. Precisely when motor M2 reaches the open position, press the SS command. Motor M2 stops.
20
The motor's current drawdown has increased very quickly
1. Leaf impact with obstacle.
2. Gate rubs during opening/closing
The control unit has received a signal from the safety edge
1. The safety edge has been pressed.
2. The safety edge is not connected correctly.
Phototest fail outcome
1. Check the photocell connections.
2. Check that the photocells are operating correctly.
Motor not absorbing power
1. Check the motor's power drawdown.
2. Check that the gate travels smoothly and that there are no obstacles.
The display returns to the normal screen.
explained in the first table in point 4.2, but also the count of the ope-
ning-closing operations performed. In the operation count display,
thousands, displayed without dots, alternate with units, displayed
with dots between them (e.g.: 50.000 = 50/0.0.0).
UP
DOWN
MENU
SS
M1 4
M2
SS
M1 M2 5
SS
M1 6
M2
SS
7
M1 M2
SS
8
M1
M2
SS
M1 M2 9
SS