Royal MARY Generalidades - Advertencias - Instalación - Mantenimiento página 25

6.4 RELOADING THE FUEL
To load fuel inside the machine while it is running, follow
the procedure below:
•
smoke to escape in the environment (based on the
draught of the fume exhaust duct).
•
Avoid overheating the stove by loading an excessive
amount of fuel.
Insert the fuel only when the grill bases are formed
The stove is provided with a bypass valve that favours
smoke transfer in the fume exhaust duct, minimizing the
smoke puffs in the environment.
6.5 ADJUSTING THE PRIMARY AIR
is regulated by the register located on the front of the
ash box door (-6.3A-). If you wish to achieve more rapid
combustion, turn the knob so that the knob is completely
open; if instead you wish to achieve slower combustion,
turn the knob so that the knob is partially open; When
it is advisable to keep the register fully open. Once the
depending on how much heat is required or how long you
lighted up, the stove can work at the nominal charge and
the combustion air register can be turned off.
6.6 ADJUSTING THE SECONDARY AIR
The stove is provided with a system that allows limiting
the soot and ash deposits on the glass and ensuring
Depending on the type of wood used, on the humidity
level and on the fume exhaust duct draught, you might
around the glass.
slot opening to aid in cleaning the glass. Its function is to
if the glass.
6.7 ADJUSTING THE DRAUGHT
The stove is provided with a draught adjustment valve for
the fume exhaust duct (-6.3C-).
The draught should be adjusted by the installer at stove
commissioning.
If the fume exhaust duct draught is optimal, leave the
valve open, if the draught is excessive close it making
sure that there are no smoke puffs in the environment if
the door is opened.
The declared nominal yield of the chimney is obtained
by burning the right quantity of wood, making sure not
to overload the combustion chamber. The ideal length of
the wood is provided by the length of the log holder.
(-6.3B-), there is a
-
+
C
B
+
A
-
fig. 6.3
25