Facom DCR.4 Guía De Instrucciones página 5

PSA ALLOCATION
PEUGEOT CTROËN
2.0 HDI 2.2 HDI 2.0 HDI 2.2 HDI
307 807 C4 C8
307 CC C5 II
308 C5 III
407 Sinergie
407 Coupé Evasion
607 Dispatch
806 (16v) Jumpy III
807
Expert
3.b RENAULT
Fit the bracket DCR.IP27 or plate DCR.IP27 plus DCR.IP28 for RENAULT Master
The beam DCR.IP25 is then laid on
the 2 brackets
Then fasten the beam with the
fl anges DCR.IP20 close to the
injector.
FIAT LANCIA
2.0 JTD 2.2 JTD 2.0 JTD 2.2 JTD
Ulysse Ulisse Phedra Phedra
Scudo Zeta
Fit the ring DCR.IP21, then the nut DCR.
IP22 and tighten until the injector is
extracted
Use a 30 mm wrench for the nut
and a 10 mm wrench for the
adapter
Then remove the nut and ring,
and pull out the injector
RENAULT ALLOCATION
RENAULT OPEL
2.2 dCi 2.5 dCi 2.2 dCi
Vessatis Trafi c II Movano
Laguna II Master II
Espace
Master II
Refi tting.
- Injectors must always be refi tted in accordance with the vehicle manufacturer's
procedures.
-Before refi tting the injector, fi rst change the gasket, after fi rst having checked
that the old one is not in the cylinder head injector bore. If the gasket is stuck at
the bottom of the cylinder head injector bore, it can be removed using
FACOM DCR.SR tool.
-Check that the injector bore and its gasket seating surface.
The FACOM DCR.IC injector bore cleaning tool can be used.
- The manufacturers recommend renewing the high pressure fuel supply lines
each time the injectors are removed. Tighten to the recommended torques.
- Some injectors require reactivation or reconfi guration using a diagnostic tool
when they have been disconnected. It certain cases, failure to perform this
operation risks damaging the engine.
NISSAN
2.5 dCi 2.2 dCi 2.5 dCi
Movano Interstar Interstar
Vivaro Primastar