Initial Start-Up - Glass 1989 SPA Manual De Uso

EN
1. Display
2. JETS key
3. Light key
4.
5.

INITIAL START-UP

when is energized. While priming mode
is activated, press "Jets" button
repeatedly and be sure the pump is free
minutes. Press "+ / -" button to exit the
programming procedure. After Priming
mode , the Spa will run in Standard Mode
(see Mode section ). The pump used for
pump".
In multi-button sequences, if buttons are
pressed too quickly one after the other they
might not take effect.
The start-up temperature is set to 37°
C. The display constantly shows last
measured water temperature.
Note that last temperature shown is the
ACTUAL spa water only when the pump
DISPLAY FUNCTIONS - Model A
10
To display temperature set, press "+" or
"-" once. To change the set temperature,
press a temperature button again before
the display stops flashing. Each time
you press "+" or "-" will adjust the set
temperature.
After three seconds, the display will stop
water temperature in the hot tub.
JETS
Press "Jets" to select the high or low
speed. If it works at low speed the pump
stops after 4 hours; if it works at high
speed, it stops after 15 minutes. The pump
can be started for at least 2 minutes every
30 minutes to detect the temperature of
the hot tub and then heat the water to the
set temperature if needed, depending on
the mode.
When the pump starts automatically at
low speed, it cannot be deactivated from
the panel; However, you can enter the
high speed.
Press the "Light" button to operate the spa
light . Turns off automatically after 4 hours.