In this way it is not possible to enter
any minipool function. It avoids any
unauthorized use of the minipool.
remain active.
To remove the locks previously activated,
EN
select the lock to be disabled and in
sequence enable the following keys:
HOLD – Temporary disabling of the spa,
water circulation and heating function.
By selecting the "Hold" string and
to enter the temporary lock function (60
minutes) of the functions spa, water
T h i s f u n t i o n c a n b e u s e d d u r i n g
replacement/ cleaning operations of the
The display shows the countdown which
indicates the time, in minutes, remaining
before the restart of the minipool normal
functioning.
In case of small maintenance interventions
do not use this function but disconnect the
product power supply for
the time necessary.
Do not use this function for interventions
access to product parts under voltage.
Maintenance is to be always carried out
compliance with existing law.
UTILITIES – Utility functions
Esci
Messaggio:
................
enter two functions.
-
permits to show on main menu display the
OK" key it is possible
Storico problemi
Entrata 2
Codice Messaggio M026
1 Giorno Fa
2:21PM
Modalità pausa
High Range
Regol.Temp 39°C
Sensori: A: 100 B:96
OK" key, it is possible to
temperature value read from both probes
situated on water heater.
- "Fault Log
"OK" key, you enter the log of the last
24 messages relating faults or important
changes in minipool state. Scrolling of the
various messages is obtained by placing
the cursor on the number close to Entry
"Down" direction keys.
It is a function reserved to technical
assistance which permits a more effective
diagnostic of the probable problems found
out, so as to make maintenance easier
reducing costs.
PREFERENCES – secondary functions
By selecting the string "Preferences"
you enter a submenu where the user
can modify his visualization and use
preferences.
- Temp Display --> it allows to set the
visualizaton of water temperature in
- Temp Display --> visualization of time
in format 24 h. or 12 h.
- Reminders --> it enables/disables the
changing.
- Cleanup --> (if present/available) it
allows to set the operating duration of
spa functions in order to improve water
- Color --> it serves to set the required
color for the display.
- Language --> it serves to change the
language of the control panel (availabla
Spanish and German).
IN FORMATION
By selecting the string "Information", you
enter a submenu showing the characteristic
parameters of the electronics mounted on
the minipool.
DIAGNOSTIC MESSAGES
MESSAGES
The lower left hand side of the display shows
26