Adjusting The Temperature; Setting Menu; Temperature Range - Glass 1989 SPA Manual De Uso

ADJUSTING THE TEMPERATURE

The temperature can be set between 16°C
By pressing the "UP" key (hotter water)
or the "DOWN" key (water less hot), the
display. Press "UP" or "DOWN" again
to adjust the temperature value. When
heating (if the value has been increased)
up to the required temperature (this is
switch off once the set temperature has
been reached).
PANEL INVERT - Inversion of the
control panel view
To invert the display screen, press the "
NOTE: this function can be implemented
from the "FLIP"setting menu via the
menu - Menu browse key").
DISPLAY
MAIN SCREEN

SETTING MENU

The "UP" and "DOWN" keys allow you to
browse the menu, whereas the "LUCE"
(LIGHT) key allows you to choose the
the subsequent entry.
To access the MENU, press the "UP" key.
the "LUCE" (LIGHT) key.
Press "LUCE" (LIGHT) several times to
access the following parameters:
- TEMP (temperature): set the temperature
- MODE: set "ready" or "rest".
- TIME: set the time.
- FLIP: display view inversion.
- LOCK: Temperature adjustment lock -
keyboard lock
- HOLD (standby): deactivates the pumps.
-
-
- PREF: preferences
- UTIL: utility
To access one of the menu "entries", press
"UP" in correspondence of the parameter
to be set (see subsequent chapters).
To exit the menu, press "LUCE" (LIGHT)
until you return to the main screen.
NOTE: if no key is pressed, the control
panel returns to normal mode after a few
seconds.
ATTENTION
press "LUCE" (LIGHT), otherwise they will
not be saved.
Menu browse key
- Indicates a change in the display
- Indicates a continuous or intermittent
message – every ½ second
- use temperature key "ON", as
- use the "LUCE" (LIGHT) key to
"setting
Time in which the chosen settings
remain available.
Time in which the initial settings are
reset deleting the changes made.
TEMP:

TEMPERATURE RANGE

This system consists of two independent
temperature range settings.
"High"
"Range High", indicated in the display
with arrow "up" [temperature between
"Range Low", indicated in the display with
arrow "down" [temperature between 10°C
These temperature ranges can be used
to set some adjustments, e.g. "ready for
use" and "on holiday".
E v e r y " r a n g e " m a i n t a i n s i t s s e t
temperature. This way, when a range
is selected the spa heats at the set
temperature which is associated to that
range.
15
EN
"Low"