Using The Control Panel - Dell 1100MP Manual Del Usuario

Using the Control Panel

1 Power
2 Source
3 Four Directional
Keys
4 TEMP warning light
5 LAMP warning light
6 Keystone adjustment If your image is not perpendicular to the screen, then it
7 Resync
4
3
2
1
Turn the projector on and off. For more information,
see "Turning Your Projector On" on page 11 and
"Turning Your Projector Off" on page 11.
Press to toggle through Analog RGB, Composite,
Component-i, S-video, and Analog YPbPr sources when
multiple sources are connected to the projector.
The four directional keys
toggle through the tabs in the OSD.
• If the Temp light is solid orange, the projector has
overheated. The display automatically shuts down.
Turn the display on again after the projector cools
down. If the problem persists, contact Dell.
• If the Temp light is blinking orange, a projector fan
has failed and the projector automatically shuts down.
If this problem persists, contact Dell.
If the Lamp light is solid orange, replace the lamp.
does not appear square. Press to adjust image distortion
caused by tilting the projector. (±16 degrees)
Press to synchronize the projector to the input source.
Resync does not operate if the on-screen display (OSD)
is displayed.
5
6
7
8
Using Your Projector
can be used to
15