Using The Dispenser - KENMORE ELITE HE 3 Plus 110.4580 Serie Manual Del Propietário

8.
9.
If desired, select the END OF CYCLE SIGNAL. The signal is
helpful when you are washing items that should be removed
from the washer as soon as it stops. Select ON or OFR
To begin the wash cycle immediately
Select and hold START (for approximately 1 second).
• If you do not select START within 5 minutes of choosing a
cycle, the washer automatically shuts off.
• When the wash cycle is complete, the CLOTHES CLEAN
status light glows, the door unlocks, and the wash load
can be removed from the washer. The washer powers
down automatically 5 minutes after the cycle is complete
and the CLOTHES CLEAN light goes off. To power down
the washer manually after the wash cycle is complete,
select PAUSE/CANCEL once.
To begin the wash cycle later
Select DELAY until the desired delay time (in hours) shows in
the Estimated Time Remaining display. Select START. The
countdown to the wash cycle will show in the display window.
• When delaying a cycle, use only powdered detergents in
the main wash compartment since liquid detergents may
seep out of the compartment during Delay, before the
wash cycle begins.
Your new washer has a dispenser drawer with three separate
compartments for your laundry products--one is for detergent,
one is for liquid chlorine bleach, and one is for liquid fabric
softener. Laundry products are diluted and dispensed
automatically at the proper time during the wash cycle, making it
unnecessary for you to return to the washer during the cycle to
add them.
It is normal for small amounts of water to remain in the
dispensers when the wash cycle is complete.
Do not put laundry additives directly into the wash tub. Always
use the proper dispensers when adding laundry products.
Choosing the Right Detergent
Use only High Efficiency detergents. The package for this type of •
detergent will be marked "HE" or "High Efficiency." This wash
system, along with less water, will create too much sudsing with a
regular non-HE detergent. Using regular detergent will likely result •
in washer errors, longer cycle times and reduced rinsing
performance. It may also result in component failures and
noticeable mold or mildew. HE detergents are made to produce
the right amount of suds for the best performance. Follow the •
manufacturer's instructions to determine the amount of detergent
to use.
Use only "HE" High Efficiency detergenL
To fill dispenser compartments
1. Pull out the dispenser drawer.
2. Add the desired laundry additive to the proper compartment.
Push in the dispenser drawer slowly and completely (to avoid
a spill).
E
Dispenser
A. Dispenser release lever
B. Separator
C. Main Wash detergent compartment
D. Liquid chlorine bleach compartment
E. Fabric softener compartment
Main Wash detergent compartment
(Letter C in Dispenser Illustration)
Add liquid or powdered HE detergent to this compartment for
your wash cycle. The detergent separator must always be in
place, either in the front or back position.
• Delaying a cycle: Use only powdered detergents. Powdered
detergents will remain in the dispenser until the cycle begins,
but liquid detergents may seep out of the compartment
during the delayed time.
Do not fill beyond the "MAX" level. Use detergent
manufacturer's recommended amount for load size.
Liquid or powdered color-safe bleach may be added to the
Main Wash compartment along with the same type of
detergent, liquid or powdered.
Liquid detergent: Put the separator in the front position,
between the guides, as shown following. There will be no gap
between the bottom of the wash cycle detergent
compartment and the bottom of the separator.
B
[] POWDER
LNQUI
SO
Separator in front position, between guides
A. Separator
B. Guide
13