Charging Process; Ingerev Garage Basic - Ingeteam INGEREV GARAGE Basic Manual De Instalacion Y Uso

Ingeteam
Status
End of charge
Incident
Standby
End of session
Card rejected

9.2. Charging process

9.2.1. INGEREV GARAGE Basic

These charging stations can optionally include a user card reader. The installation process for each case are
described below.
The electrical supply connector must not be removed from the vehicle while the charging is being
carried out.
Types of charge
The charging station has two charge modes: nominal (N) and limited (L).
Selecting the nominal charge process the station will carry out the charge with its nominal current.
Limited charge type charges at 10 A for the 20 A nominal current model, or at 20 A for the 32 A nominal current
model, whereby the charge process is longer.
Starting the charging process (without a card reader)
1. Insert the key in the side of the station and select the type of charge required. To select nominal charge,
turn the key clockwise to the N position. Conversely, if you require a limited charge to be carried out, turn
the key clockwise to the L position. The key can be left in the slot or it can be removed as required by the
user. Removing the key ensures that the charge process selection is not modified by third parties.
The front LEDs flash yellow when waiting for a vehicle to be connected.
It is possible to change the type of charge during the charging process by turning the key to the required
position.
30
Lighting
Flashing yellow INGEREV GARAGE Basic without RFID reader
After a vehicle has been charged, a user has selected the stop position
(0) with the key and the charging station is waiting for the vehicle to be
disconnected.
INGEREV GARAGE Basic with RFID reader, INGEREV GARAGE Wall,
INGEREV GARAGE One
After a vehicle has been charged, a user has identified their card using the
reader and the charging station is waiting for the vehicle to be disconnected.
Continuous red The charging process is not being carried out correctly due to a problem.
None The charging station has been remotely shut down.
Steady white The charge has finished.
Steady white INGEREV GARAGE Basic without RFID reader
Not applicable.
INGEREV GARAGE Basic with RFID reader, INGEREV GARAGE Wall,
INGEREV GARAGE One
The card is not valid or has not been recognized.
Description
ABA2021IQM01_A - Installation and Operation Manual
Operation