Securing Child - Nuna pipa Manual De Instrucciones

The safety belt must go under the lock-off, not over the
(21) -1
lock-off.
The safety belt must be locked into the buckle.
The load leg must be installed correctly with green
(21) -3
indicator.
5 Push the car seat down into the base
seat is secure, the car seat indicator shows green.
Pull up on the car seat to be sure it is securely latched
into the base.
6 To release the car seat, pull the car seat up while squeezing
the car eat release button.
Installation with ISOFIX System
1 Unfold the load leg from storage compartment.
2 Fit the ISOFIX guides with the ISOFIX anchor points.
The ISOFIX guides can protect the surface of the vehicle
seat from being torn. They can also guide the ISOFIX
connectors.
3 Rotate the ISOFIX connectors 180 degrees until they are
pointing in the direction of the ISOFIX guides.
4 Line up the ISOFIX connectors with the ISOFIX guides, and
then click both ISOFIX connectors into the ISOFIX anchor
(27)
points.
Make sure that both ISOFIX connectors are securely
attached to their ISOFIX anchor points. There should
be two audible clicks and the colors of the indicators
on the both ISOFIX connectors should be completely
(27) -1
green.
Check to make sure the base is securely installed by
pulling on the both ISOFIX connectors.
5 Please refer to step 2 in section 'a. Installation with
3-point-belt' for adjustment of load leg.
The completely assembled base is shown as
The ISOFIX connectors must be attached and locked
27
(21) -2
(22)
, if the car
(24)
(18)
(25)
(26)
(28)
onto the ISOFIX anchor points.
The load leg must be installed correctly with green
(28) -2
indicator.
6 Please refer to step 5, 6 in section 'a. Installation with
3-point-belt' to use the infant car seat.
7 To remove the base, pull the base backwards while pressing
the buttons on the ISOFIX connectors.
Securing
child
Foam inside infant insert is present to ensure that harness
fits child properly. Infant insert must be used for children 0-6
months.
After the child is placed into the seat, check whether the
Shoulder Harness Straps are at proper height.
1 While pressing the adjustment button located at the front of
the infant car seat, pull completely the two Shoulder Harness
Straps of the infant car seat.
2 Unlock the buckle of the harnesses by pressing the red
(31)
button.
3 Place the child into the infant car seat and lock the buckle.
(32) (33)
Please refer to.
4 Tighten the shoulder harness straps by pulling the
(34)
adjustment webbing.
Make sure the space between the child and the Shoulder
Harness Straps is about the thickness of one hand.
(28) -1
(29)
(30)
28