Securing Your Child - Nuna Myti Manual Del Usuario

5
- Press the ISOFIX release button and push the base back against the
vehicle seat until tight. (19)
6
- To extend top tether for use, press button on tether adjuster and pull to
lengthen. (20)
7
- Connect the tether hook securely to the anchorage fitting. (21)
Use top tether for installation if vehicle is equipped with a tether
anchorage fitting and vehicle requirements are met (see vehicle owner's
manual).
8
- Make sure that tether hook are securely attached to the anchorage
fitting. (22) The colors of the indicators on tether strap adjuster should
be completely green.
9
- The colors of the indicators on tether strap adjuster should be completely
green. (23) -1. The colors of the indicators on both ISOFIX connectors
should be completely green. (23) -2
Removing the enhanced child restraint
1
- Press the release button (24) to loosen the webbing and then detach the
hook to remove the top tether. (25)
2
- To remove ISOFIX attachments from the vehicle's anchor points press
the ISOFIX release button and pull the base back from the seat. (26)
3
- Then press and pull back on the ISOFIX connector on both sides. (27)
4
- For easy transporting, press the ISOFIX button and move the ISOFIX
attachment back so it is stored completely. (28)

Securing your Child

1
- Press the webbing adjustment button, while pulling out the shoulder
harnesses to the proper length. (29)
2
- Press the red button to disengage the buckle. (30)
3
- Place the buckle tongues against the magnetic area on the outer side of
the child restraint so that the tongues are held in place. (31)
4
- Please use the infant insert to support the child if the child's shoulder is
lower than the headrest bottom edge. (32)
5
- Place the child into the enhanced child restraint and pass both arms
through the harnesses. (33)
11
MYTI Instructions
6
- Engage the buckle. (34)
The green indicator shows that it has been buckled in place.
7
- Pull down the adjustment webbing and adjust it to the proper length so
that your child is snugly secured. (35)
Always keep child secured in harness and properly tightened by
removing any slack.
A too loose harness can cause severe injuries in case of an accident.
8
- The webbing is able to store under the soft goods. (36)
Using in the Junior Mode
(Child height 100cm-150cm/Approx. 3 years - 12 years old)
1
- Store the shoulder strap cover, crotch belt cover, lap strap cover in a safe
place. (37)
2
- Store the buckle and harness straps in a safe place. (38)(39)(40)
Securing your Child
For installation with 3-point belt
1
- Please check whether the vehicle shoulder belt guides are at the proper
height that the bottom of the headrest MUST be even with the top of
child's shoulders.
2
- Position the shoulder belt through the shoulder belt guide and pass the
lap belt through the lap belt slots. Engage the vehicle buckle. (41).
Shoulder belt must pass through shoulder belt guide. (42)-1
Lap belt must pass through lap belt slots. (42)-2
The enhanced child restraint can not be used if the vehicle safety belt
buckle (female buckle end) is too long to anchor the enhanced child
restraint securely. (42)-3
NEVER use a 2-point vehicle belt (lap-belt only) to secure your child.
DO NOT use shoulder belt loose or positioned under arm.
DO NOT use shoulder belt behind child's back.
DO NOT allow child to slide down in the enhanced child restraint in case
of strangulation.
12
MYTI Instructions