Descargar Imprimir esta página

Securing Child; Installation Without Base - Nuna Bugaboo Turtle Air Manual Del Usuario

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 58

Securing child

Use infant insert
We recommend using the full infant
insert while the baby is under 60 cm
or until they outgrow the insert.
The infant insert increases side
impact protection.
After the child is placed into the seat, check whether the
Shoulder Harness Straps are at proper height.
1
While pressing the harness adjustment button, pull
completely the two Shoulder Harness Straps of the
enhanced child restraint. (22)
2
Unlock the buckle of the harnesses by pressing the red
button. (23)
3
Place the child into the infant carrier module and lock
the buckle. (25) Please refer to (24).
4
Tighten the shoulder harness straps by pulling the
adjustment webbing. (26)
Make sure the space between the child and the
Shoulder Harness Straps is about the thickness of one
hand.
18
BGB Nuna Turtle 2 UG_rv001 Part1 120x170.indb 18-19
BGB Nuna Turtle 2 UG_rv001 Part1 120x170.indb 18-19
All manuals and user guides at all-guides.com
Remove the infant insert
side wings when the infant's
shoulders no longer fit
comfortably.
Canopy
1
Flip out visor from underneath the front canopy bow.
(27)
2
Pull out the extendable 'smart visor' from in between
the two visor layers. (28)
3
Attach the magnets on each corner to the front of the
child seat. (29)
4
The Peek-a-boo on the back can be opened for
ventilation. (30)
To fold back the canopy, first flip back the visor
underneath the front canopy bow and then fold back
the extendable smart visor underneath.
Detach & assemble soft goods
see images (31)-(40)
To re-assemble the soft goods, reverse the aforementioned
steps.

Installation without base

1
DO NOT install this infant carrier module on vehicle
seats with Lap Belts. (41)
2
This infant carrier module is suitable for vehicle seats
with a 3-point Retractor Safety Belt (without base) only.
(42)
3
Place the infant carrier module onto the vehicle seat
where you wish to put it. Pull the vehicle safety belt out
and lock it into the vehicle buckle, sliding the vehicle
lap belt into the side guides of the infant carrier module.
(43)
19
22-02-2020 18:33
22-02-2020 18:33

Publicidad

loading