Nostalgia Electrics CCP399COKE Manual De Instrucciones página 10

Assembly of Wheels
1. Insert Axle Rod (F) into Base Support (I).
2. Put on #4 Flat Washer. Slide Wheel (G) into Axle Rod (F) and
add a second #4 Flat Washer.
3. Use the end of Wrench (H2) with small notch to hold the Axle Rod notch in place.
While holding Axle Rod (F) in place, tighten the #5 Nut Cap with Wrench (H1).
4. Add #4 Flat Washer, second Wheel (G), another #4 Flat Washer, and #5 Nut Cap
to the other side of the Axle Rod (F), following the directions above.
(#4)
Flat
Washer
(#5)
Nut
Cap
(F)
Axle
Rod
(I)
(G)
Base
Wheel Support
8