Jacuzzi moove blower Manual De Instalación, Uso Y Mantenimiento página 10

The blower (or... the "magic bubbles")
I Fill the tub up with the same amount of water that you would
use for a normal bath.
I If you have not already done so, turn on the main switch lo-
cated on the power supply line of the tub.
I Press the key to initiate the function: the key will light up
blue and the blower will activate.
NOTE: where the water level is inadequate, the light will flash
for approximately 5 minutes and the function cannot be initiat-
ed. You must add water and press key again.
I After 30 minutes, the function comes to an end and the blue
light goes off. You can however stop the function anytime y-
ou wish by pressing the key (A).
Drainage of the blower circuit (flashing blue LED):
models with a blower, after about 5 minutes after the tub is
emptied (when the sensor no longer detects water in the tub)
the blower is automatically activated for about 30 seconds. This
is to force out any remaining water (which got in while filling
the tub) from the pipes connected to the nozzles on the bot-
tom of the tub.
You can activate this phase manually if you like, without hav-
ing to wait the 30 minutes previously mentioned:
- wait for the tub to drain completely.
- Touch key with your finger. The blower will come on for 30
seconds, and then you can turn off the main switch located on
the power supply line of the tub.
NOTE: the phase for cleaning the pipes can be activated on-
ly once, again with the tub empty, unless you reset the elec-
tronics via the main switch. If you turn the main switch off and
back on, you can re-activate the blower (by pressing key) even
if there is an insufficient amount of water in the tub. Howev-
er, the function will shut off automatically after the 30-second
period referred to previously; basically, the pipe-cleaning phase
is activated. If you want to use the blower function, you will
need to fill the tub correctly.
We suggest a hydromassage duration of about 15-20 minutes,
as it normally takes about 5 to 10 minutes for the revitalizing and
energizing effect of the moving water to take effect.
I We recommend you set the water temperature to 36 °C, even if
the duration of the hydromassage and the temperature of the
water are highly subjective factors, connected with the type of
treatment, physical conditions, or habits and preferences
At high water temperatures, we do however recommend de-
creasing the duration of the hydromassage, for example:
(°C)
34 - 36
36 - 38
38 - 40
Warnings
Soap or bubble bath (if not specifically intended for hy-
dromassage use) should be used only if you are not us-
ing the hydromassage.
Always remember to switch off the hydromassage before
emptying the tub.
I Attention: if the tub is cleaned a long time after emptying
in
it and without turning off the main switch, the level sensor
may detect water in the tub (holding a wet cloth over it for a
few seconds, or pointing the jet of water at the area where the
sensor is). Therefore, after 30 minutes, the blower will be au-
tomatically activated for about 30 seconds in order to expel any
water which may be present in the pipes of the blower.
If the sensor does not detect the presence of water, or if
the tub is cleaned with the switch off, you can drain the tub
as described previously.
IN CASE OF DIFFICULTY...
I The blower (air bubble generator) does not start
•
Check that the main switch on the power supply line to the
bath is on.
I The blower (air bubble generator) stops of its own accord
Check that the electrical power supply has not been cut off.
The length of the hydromassage has been set in the factory to be
about 30 minutes, so that after this time the cycle stops by itself.
•
Press the appropriate key again if you want to re-start the cycle.
If for any reason the level of water drops below the minimum lev-
el, the blower will shut down and the cycle will automatically come
to an end. The LED for the key will flash for about 5 seconds and
an intermittent acoustic signal of about 2 seconds will indicate
that there is an error.
•
Fill the tub as required and press the appropriate key again
if you want to re-start the cycle.
(min)
20
15
10