General Guidelines; Cleaning And Maintenance - HQ-Power VDSABS8A Manual De Instrucciones

Ocultar thumbs Ver también para VDSABS8A:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

3. General Guidelines

• This device is designed for professional use on stage, in discos, theatres, etc. The VDSABS8A should only be used
indoors with the included power adapter connected to an alternating current of max. 230V AC/50Hz.
• Do not shake the device. Avoid brute force when installing or operating the device.
• Select a location where the device is protected against extreme heat (see "Technical Specifications"), dust and
moisture.
• Familiarise yourself with the functions of the device before actually using it. Do not allow operation by unqualified
people. Any damage that may occur will most probably be due to unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks, crash,
etc. Using the device in an unauthorised way will void the warranty.
4. Installation
• Install the device in a location where few people pass by and that is unreachable for unauthorised persons.
• Make sure there is no flammable material within a 50cm radius of the device.
5. Use
• Make sure the power switch is set to "OFF".
• Insert the DC jack of the adaptor into the device and plug the adaptor into the mains outlet.
• Set the power switch to "ON". The device starts operating.
• Set the power switch to "OFF" to stop the device.
1. Power button "1" on and "0" off.
2. Power input jack.
3. Low tone level control, 12dB raising attenuation at 100Hz.
4. Hi tone level control, 12dB raising attenuation at 3.5 KHz.
5. Volume control of RCA line input.
6. Volume control of MIC input.
7. Microphone ¼" input jacks, can receive unbalance signals.
8. RCA (R.L) input jack, can receive both balance and unbalance signals.
9. Line output ¼" jack +4dB.
10. Input signal overload indicator.

6. Cleaning and Maintenance

1. All screws should be tightened and free of corrosion.
2. The housing, visible parts, mounting supports and the installation location (e.g. ceiling, suspension, trussing) should
not be deformed, modified or tampered with e.g. do not drill extra holes in mounting supports, do not change the
location of the connections.
3. Moving mechanic parts must not show any signs of wear and tear.
4. The electric power supply cables must not show any damage. Have a qualified technician maintain the device.
5. Disconnect the device from the mains prior to maintenance activities.
6. Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
7. There are no user-serviceable parts.
8. Contact your dealer for spare parts if necessary.
VDSABS8A
2
VELLEMAN

Publicidad

Tabla de contenido
loading

Tabla de contenido