Installation Precautions - Astralpool BASIC Manual De Instalación

3. Installing Basic™
YOUR IMMERSION DETECTOR MUST BE INSTALLED IN GOOD WEATHER ON
A STILL POOL.
The alarm system must be installed at a location where the pool is at least 30 cm deep.
Make sure that the water in your pool is clear and pure before installing your device.
DO NOT USE AN ELECTRIC SCREWDRIVER to install the device.
Some robot cleaners like the diving robot are incompatible with immersion detection systems.
Your immersion detector is installed in 7 steps:
3.1 Attachment of rigid tube
3.2 Insertion of the batteries
3.3 Choice of location
3.4 Temporary installation
3.5 Installation tests
3.6 Final installation
3.7 Validation tests
UTMOST VIGILANCE IS REQUIRED FROM THE PARENT/RESPONSIBLE ADULT
DURING THE INSTALLATION OF YOUR IMMERSION DETECTOR
Tools required for installation:
I 1 Phillips screwdriver
1 tape measure
I
I Four 1.5 L. water bottles
I 1 roll of sticky tape
1 rope about 2 meters long.
I
I 1 drill with a Ø8 mm concrete bit
1 hacksaw
I
I 1 pair of shears or heavy-duty scissors

INSTALLATION PRECAUTIONS

4