Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
To ensure optimum operation, the probe must be immersed 22 cm (± 3cm) deep.
If the water level has been deliberately lowered, suitable probe extenders are available
from your retailer.
The water level must be checked regularly, and restored if required to maintain
an immersion depth of 22 cm (± 3cm). The installation of a level controller is
recommended. Contact your retailer for advice.
If the probe is immersed too deep or nor deep enough (or even not at all), your immersion
detector will not be able to operate properly. Please make sure that the recommended
immersion depth is respected.
3.4. Temporary installation / Installation temporaire
For installation tests, we recommend that you do not first switch off the probe, but you lift up
the device (on a book, flat stone, brick, wooden board, etc.) to obtain an immersion depth of
22 cm (+ /-3 cm). You must ensure that the device remains stable during the fall tests.
1
x 4
x4
Place the 4 pieces of stabilizing foam.
22cm
±
(
3cm)
2
x 1
x1
Place the wedge plug (included in the fastening
kit) at the end of the tube.
7
Publicidad
Tabla de contenido
