Install Pet Door - Petsafe HPA11-10987 Guia De Instalacion

5
Step

Install Pet Door

the underside of the opening to check the fit. If the screw holes on frame are not visible
through cut-out, you may need to recut opening before proceeding with the installation.
5A
5B
5C
8
Before putting away jigsaw, place the exterior frame (frame with 1 flap) into
Optional
Customer Care Center 1-800-732-2677
5A Place interior frame (frame with 2 flaps) into cut-out.
Next place exterior frame into cut-out from under side
of door, inserting core covers inside tabs of frame. Hold
frame together. Insert nylon screws through holes in
interior frame into holes in exterior frame. Thread a hex
nut onto bottom of each screw.
Helpful Tip: Use saw horses, table or other work surface
to hold exterior frame in position while installing pet
door.
Helpful Tip: Look through screw holes to help align
interior and exterior frames.
5B Use a screwdriver to evenly tighten screws through-
out frame while keeping core covers in position. It may
be necessary to adjust screws to make sure pet door fit
is correct.
Helpful Tip: Look though flap opening to check if core
covers are in position as you tighten the screws.
5C Use wire cutters to trim screws flush with exterior
frame.
Use a manual screwdriver to tighten screws. Do not
overtighten. Overtightening can strip the screws or
warp the pet door frame.
Caulk around the exterior frame (frame with
Optional:
one flap) and inside threshold where core covers meet for
weather resistance.
NOTICE