Leviton MDNCT-2SC Manual Del Usuario E Instalación página 18

4 GENERAL METERING FEATURES AND FUNCTIONALITY
Error Meter
Category Status
None NORMAL
Low
Warning
Current
Reverse
Installation
Energy
Bad
Installation Power
Factor
Low
Installation
Voltage
Over
Installation
Voltage
Over
Installation
Current
Factory
Failure Service
Required
While in a failure condition, in addition to displaying a "FAIL" code on the error screen the
screen ID (leftmost digit) on every screen blinks, alternating between the screen ID and the
character "F".
For a single-element meter, no errors are reported on line 2.
If the meter reports an installation error, refer to Section 6 for troubleshooting. If the meter
reports a failure condition, contact Leviton technical assistance.
LCD
Error Bar/Arrow
Message
Animated arrow
None
pointing right
Bar and arrow
None indicators turned
off
Err rC1 or Arrow pointing
Err rC2 left (no blink)
Solid bar (no
Err PF1 or
blink), no arrow
Err PF2
either side
Solid bar (no
Err LU1 or
blink), no arrow
Err LU2
either side
Err HU1 Solid bar (no
or Err blink), no arrow
HU2 either side
Err HC1 Solid bar (no
or Err blink), no arrow
HC2 either side
FAIL 01
Blinking bar, no
FAIL 02 ...
arrow either side
FAIL 05
Table 7 - LCD Indications
15
L1/L2 Determination of
Symbols Error Condition
No error or warning
Both off
conditions.
Blinking Power greater than
(one or or equal to -15W but
both) less than +15W.
Blinking
Power less than
(one or
-15W.
both)
Checked only when
current is greater
Blinking than starting current
(one or level. Error when
both) phase angle is
greater than 80°
and less than 90°.
Blinking
(one or Voltage below 102V.
both)
Blinking
Voltage above
(one or
138V.
both)
Current above 110A
Blinking if configured for
(one or 100A CT or 220A if
both) configured for 200A
Operational error
Both off
detected.
CT.