Wasserlab Micromatic DA Manual Del Usuario página 16

0. Introduction
This User Manual provides information about the installation,
start-up and routine maintenance tasks of the Micromatic
equipment.
Before start-up, carefully read the instructions regarding the
safety of the device, as well as its electrical and hydraulic
connection aspects.
The User Manual also contains additional information about
the equipment and settings, allowing a better understanding of
the operation and care required.
If in doubt, please contact your local distributor or the
Wasserlab technical assistance service.
SAT Wasserlab
Tel: 948 186 141 Fax:
Fax: 948 281 808 Fax:
e-mail: sat@wasserlab.es
Manufacturer:
Navarra de Tratamiento el Agua S.L.
CIF: ES B31 637580
Pol. Ind. Mocholí, Plaza Cein, 5
31010 Noain (Navarra). Spain
1. Index
0. Introduction ..................................................................... 2
1. Index ............................................................................... 2
2. Safety information........................................................... 3
3. Equipment use and specifications .................................. 4
3.1 Electrical power requirements................................. 4
3.2 Equipment location..................................................4
3.3 Equipment features .................................................4
4. Equipment description .................................................... 5
4.1 Equipment exterior .................................................. 5
4.2 Right side .............................................................. 5
4.3 Left side.................................................................. 5
4.4 Other elements........................................................ 5
4.5 Screen and keyboard.............................................. 6
4.6 Tank of Water produced......................................... 6
5 Water purification process description............................ 7
5.1 Pretreatment ........................................................... 7
5.2 Reverse osmosis..................................................... 7
5.3 Deionisation ........................................................... 7
5.4 Type II Water Storage ............................................. 7
5.5 Automatic operation of the equipment .................... 7
6. Hydraulic diagram........................................................... 8
7. Equipment installation .................................................... 8
7.1 Unpacking the equipment ....................................... 8
7.2 Hydraulic connections ............................................. 9
7.3 Equipment start-up ................................................ 10
8. Monitoring ..................................................................... 11
8.1 Symbols and meanings .........................................11
8.2 User warnings ....................................................... 12
8.3 Entering parameters (set-up menu) ...................... 12
9. Maintenance ................................................................. 13
9.1 Pretreatment replacement..................................... 13
9.2 Resin cartridge replacement ................................. 13
9.3 RO membrane replacement.................................. 14
10. Calibration .................................................................. 14
11. Troubleshooting Guide .............................................. 15
12 EC Declaration of Conformity...................................... 16