Electrical Power Requirements; Feed Water Requirements; Equipment Location; Equipment Features - Wasserlab Micromatic DA Manual Del Usuario

3. Equipment
specifications
Micromatic water purification equipment provides Type II
purified water (ASMT) from the tap water.
The equipment combines several processes to supply purified
water (pre-filtration, reverse osmosis and deionisation).
The water provided by the equipment is suitable for numerous
laboratory techniques, preparation of culture media and other
applications requiring Type II purified water.
Once the equipment has been connected and started up,
operation is automatic.
The purified water of the Micromatic equipment is not fit for
human consumption.

3.1 Electrical Power Requirements:

230V AC / 50 Hz Single-phase / 36W.
Use only the transformer supplied with the equipment.
The power point should not be situated below the
equipment.

Feed water requirements:

Drinking water (according to European or USA
standards)
Maximum Inlet
pressure
Minimun. Inlet
pressure
Temperature:
Maximum hardness:
SDI (Silt Density
Index)
Conductivity
Free Chlorine:
Turbidity:
Deviation from the feed value requirements may cause
deterioration of the equipment components and/or a
decrease in performance.

Ambient temperature

Operation: 5ºC – 35ºC
Storage: 5ºC – 35ºC
The ambient temperature and, above all, the feed water
temperature affect the equipment's performance.
The ideal operating temperature is in the range between
20 - 25°C.
If the equipment may be submitted to low temperatures,
make sure it is no less than 5°C.
use and
6 bar.
3 bar
5ºC – 35ºC
360 ppm
(CaCO
)
3
< 5
< 1500 µS/cm
<2 ppm
< 1 NTU
Relative humidity HR = No condensation. HR < 80% for
Temp. up to 31°C (linear decrease up to 50% at 40°C).

3.2 Equipment location

The equipment is designed for indoor use and < 2000 m
altitude.
The location of the equipment must not obstruct the
access to the electric connection.
Make sure that the rear connections of the equipment
are not adversely affected by an inappropriate location.
An easily accessible stopcock must be installed
between the tapping point and the equipment inlet in
case the water supply must be cut.
The equipment needs a drainage to collect the rejection
water.

3.3 Equipment features:

Production flow *:
Operating pressure:
Conductivity
(compensated at 25°C)
Silica removal:
Reverse osmosis performance:
Equipment dimensions:
Height
Width
Depth
Weight in operation
* 15% fluctuation. The production values are based on
standard operating conditions [25 °C / pH 5 - 7 / 4 bar/250 ppm
NaCl] and may vary depending on the feed water quality and
typical variations in the reverse osmosis membranes.
2.5 l/h *
2.5 - 6 bar
< 0.2 |jS/cm
>99.9 %
90 - 98%
45 cm
25 cm
40 cm
13 Kg