Operating Guide; Prepare The Handheld Remote; Prepare The Receiver Collar; Charge The Receiver Collar - Petsafe HDT11-13910 Instrucciones De Uso

Step 1

Prepare the Handheld Remote

Charge the Handheld Remote
1. Lift the rubber cover protecting the Handheld Remote
Charging Jack.
2. Connect one of the charger connectors to the Handheld
Remote Charging Jack (1A).
3. Plug the charger into a standard wall outlet. The red light
will appear.
4. Charge the Handheld Remote for 24 hours for the first
charge. Recharges take only 12 hours.
Note: The Remote Indicator Light is solid green after 12
hours of charging. For the first charge, continue to charge
the Handheld Remote for an additional 12 hours.
5. When charging is completed, replace the rubber cover.
Note: Approximate battery life between charges is 40 to 60
hours, depending on frequency of use.
Remote Indicators
Condition
Normal Operation
Normal Operation - Low Battery
Tone A/Tone B
Stimulation
Program Mode - Button Held
Program Mode - Button Released OFF
Charging
Charging Complete
Step 2

Prepare the Receiver Collar

Charge the Receiver Collar

1. Lift the rubber cover protecting the Receiver Collar Charging Jack.
2. Connect one of the charger connectors to the Receiver Collar Charging Jack (2A).
3. Plug the charger into a standard wall outlet. The red light will appear.
4. Charge the Receiver Collar for 24 hours for the first charge. Recharges take only 12 hours.
6

Operating Guide

Dual Color LED
RED LED
OFF
Flashes three times every 5 secs. OFF
OFF
ON length of button press
OFF
ON
OFF
Customer Care Center 1-800-732-2677
1A
Charger connector placed
in the Handheld Remote
Charging Jack
GREEN LED
OFF
ON length of button press
OFF
ON length of button press
Flashes mode number
OFF
ON